topblog Ivoire blogs

23/03/2019

VCM2 clone and Ford Mustang 2006 PCM Reprogramming: Success!

Have used VCM2 SP177-C1 for reprogramming PCM on FORD MUSTANG 2006 in bank. Ready to light, just cycle keys.

vehicle specs:

vehicle: Mustang

engine type: 3v

capacity: 4.5l

transmission: automatic

fuel type: gasoline

emission level: so state emission

vcm2-FORD-MUSTANG-1

programmable module installation - pcm

vcm2-FORD-MUSTANG-2

install a new module in the vehicle

vcm2-FORD-MUSTANG-3

vcm2 sp177-c1 is working

vcm2-FORD-MUSTANG-4

erase procedure in progress

vcm2-FORD-MUSTANG-5

pcm reprogramming...pls wait

vcm2-FORD-MUSTANG-6

pcm reprogramming:

if required, obtain a pcm reprogramming label and complete with the following data

note: a reprogramming lablel is not required on vehicles serviced in the North America

date:

part:

place the completed label in the appropriate position

vcm2-FORD-MUSTANG-7

read vehicle information using Launch crp123

vcm2-FORD-MUSTANG-11 vcm2-FORD-MUSTANG-8 vcm2-FORD-MUSTANG-9 vcm2-FORD-MUSTANG-10

pcm reprogramming...

vcm2-FORD-MUSTANG-12

changing security access

vcm2-FORD-MUSTANG-13

on the table

vcm2-FORD-MUSTANG-14

Done!

Source: http://blog.cardiagtool.co.uk/

21/03/2019

How to read/write Volvo XC90 EDC17C11 via boot mode

It's aimed to help people with reading and writing bosch edc15c11 for a volvo xc90 2.4d5 2005 model?
There are different ways to do it.

MPPS - boot mode:

only boot mode
I'm did this ECU in boot with mpps

Galletto - boot mode:

I read EDC15C11 just a few days ago with galletto and used the diagram posted above here. No problem reading/writing.
FYI, you have to make checksum before writing new file, since galletto does not support chksum correction on these ECUs

Kess V2 - boot mode:

I made a few of these ECUs from Kess V2 via bootmode without any problems.

Use the help files of ksuite... its easy...

kess-v2-boot-mode-volvo

wiring diagram

kess-v2-boot-mode-volvo-wiring-diagram

connection

kess-v2-boot-mode-volvo-connection

20/03/2019

How to do CAS 3 ++ ista-p by vvdi prog and vvdi2

Question: Can I do CAS 3 ++ ista-p by vvdi prog and vvdi2? I have a one operating KEY (keyless)

Answer: Yes. it's easy. about how to add a new key, there are some on youtube.

Here is suggestion from the experienced users.

Tony Curran:

Pretty easy, takes around 10 minutes after downgrading cas

All obd with vvdi2

Arturs Bedre:

Strongly suggest You take out cas & do this on table. Read out eeprom and make key with eeprom data ...

Curtis C J Perry: 

I'd do this bench. It's so much safer (downgrading can corrupt flash data) and you have the benefit of having the Immo data for new keys in the future. Creating a backup of EEPROM and Flash is crucial IMO

Andy James:

Yes, take out cas and read eeprom with vvdi prog. You can get Isn from working key, then do file make key with the Isn and your done

No downgrade needed!