topblog Ivoire blogs

03/05/2018

Ten steps to read EWS3 0D46J from BMW E39 with Xprog-M

I’d like to show you how to read EWS3 0D46J from BMW E39 using a Xprog-M programmer.

xprog-m-read-ews3-1

The EWS 3 Immobilizer unit , in the BMW E39 car body, is above the pedals, on the left.

xprog-m-read-ews3-2

remove it.

xprog-m-read-ews3-3

take the board out of the case.

xprog-m-read-ews3-4

The immobilizer is assembled on a Motorola microcontroller with a mask of 0D46J . Read it will be the Xprog-M programmer .

xprog-m-read-ews3-5

Open the program, go to Device s - Immobilizers - BMW - EWS3 .

xprog-m-read-ews3-6

looking at the connection diagram.

xprog-m-read-ews3-7

According to the scheme, connect the programmer Xprog-M to the immobilizer block EWS 3 .

xprog-m-read-ews3-8

Click the Read button ...

xprog-m-read-ews3-9

... And the firmware Motorola 0D46J is read.

xprog-m-read-ews3-10

Job’s done!

More ECU Programmer Info:http://www.cardiagtool.co.uk/wholesale/auto-ecu-programmer/

02/05/2018

6 steps to assemble vvdi be key pro with smart key shell

How to assemble VVDI BE Key Pro imrpoved version with the Smart Key Shell 3 Button for Mercedes Benz?

 

 

1. Put the VVDI BE key Pro improved version PCB into the case.

 

 

 

2. Cover the bottom case.

 

 

3. Insert the battery and cover the case.

 

4. Push the metal strips on both sides into the right position.

 

5. Here rearmetal button.

 

 

6.Put into the small key and start button.

 

 

If you want to disassemble the case, please do it from the last step to the first step.

 

 

Note: If the rear metal component is firstly assembled, then the metal strips on both sides won't be able to put into the right position.